SDP-25SURROUND SOUND PROCESSOROWNER'S MANUAL
- 10 -JBL SYNTHESIS SDP-25GENERAL SETUPBefore making initial setup adjustments you may wish to change some of the system settings that will make it ea
- 11 -JBL SYNTHESIS SDP-25Global Lip Sync: This setting adds delay of 10ms to 500ms (in 10ms increments) to the program audio on all inputs so that it
- 12 -JBL SYNTHESIS SDP-25Note that the default name that is shown when the entry box first appears is indented a few spaces. If you wish to position
- 13 -JBL SYNTHESIS SDP-25SPEAKER CONFIGURATIONSpeaker CongurationFront L/R 80HzCenter 80HzSide L/R 80HzRear L/R 80HzHeight L/R NoneSubwoofer
- 14 -JBL SYNTHESIS SDP-25SPEAKER LEVELBefore making any Speaker Level adjustments, first set the volume to a comfortable listening level using a movi
- 15 -JBL SYNTHESIS SDP-25- 15 -You may adjust the levels in one of three ways:• To have the test noise automatically circulate use the settings des
- 16 -JBL SYNTHESIS SDP-25The default setting is Off, but by highlighting Dolby Volume and then pressing Enter and then using the Up/Down Navigation B
- 17 -JBL SYNTHESIS SDP-25MAIN ZONETo select an input, simply press the button on the remote or front panel corresponding the desired source and adjus
- 18 -JBL SYNTHESIS SDP-25 Troubleshooting GuideTROUBLESHOOTINGIncorrect connections, configuration or operation is sometimes mistaken for product mal
- 19 -SPECIFICATIONSMAIN ZONE AUDIOFrequency Response: 20 Hz – 20 kHz, ±0.25dBAnalog Input Impedance: 47K ohmsInput Level: 4 Vrms in DSP modes 4 Vrms
- 2 -JBL SYNTHESIS SDP-25TABLE OF CONTENTSIntroduction & Features ... 2Installation & Setup ..
HARMAN International Industries, Incorporated 8500 Balboa Boulevard, Northridge, CA 91329 USA© 2015 HARMAN International Industries, Incorporated. All
- 3 -JBL SYNTHESIS SDP-25 Front Panel Controls and IndicatorsStandby/On Indicator: This LED indicator will light red when the AC mains power is applie
- 4 -JBL SYNTHESIS SDP-25 Rear Panel ConnectionsHDMI Inputs: Connect the output of an HDMI source device to these jacks.HDMI Outputs: Connect these ja
- 5 -JBL SYNTHESIS SDP-25 Rear Panel ConnectionsIR Flasher Input: Connect the output of a modulated IR signal from a simple IR receiver to this input
- 6 -JBL SYNTHESIS SDP-25 Information DisplayChannel Indicators: These will light to show which channels are active based on the input format and proc
- 7 -JBL SYNTHESIS SDP-25REMOTE CONTROLPower Toggle: Press this button to turn the unit on or place it in the Standby Mode.Power On: Press this button
- 8 -JBL SYNTHESIS SDP-25CONNECTIONSSAFETY NOTE: When making connections between the SDP-25 and any other device be certain that both the SDP-25 and o
- 9 -JBL SYNTHESIS SDP-25SYSTEM CONNECTIONSIf your SDP-25 is installed in a cabinet or in a way that the front panel IR sensor is not visible, externa
Komentáře k této Příručce